Easy Tricks With Ribbon for Wrapping Packages

Download Article

Download Commodity

You've got your souvenir all wrapped up and prepare to become. All it needs is a pretty bow–and tying a ribbon bow effectually the box will give you a nicer, fancier experience than using a stick-on bow. Nosotros'll show yous how to tie a basic ribbon bow as well every bit how to create a diagonal bow and a fancy woven look around your gift box!

1. ane

   Drape the ribbon horizontally beyond the top of the box. Leave well-nigh iv to viii inches (x.16 to twenty.32 centimeters) hanging off the side for the tail of the bow. Exercise not cutting the ribbon yet.^[i]

   • It's better to get out more ribbon hanging off the side than besides little. You can always cut it shorter after.

2. 2

   Pull the rest of the ribbon under the box and dorsum to the front. Don't flip the box over, or y'all may lose your place. Instead, lift the box upwards and bring the rest of the ribbon behind it. Ready the box back downward once the ribbon comes out the other side.^[2]

   Advert

3. 3

   Cantankerous the ribbons across the front of the box. Bring the ribbon towards the eye of the box, so bring the shorter end to meet it. Twist the ribbons around each other and so that they are oriented vertically.^[3]

   • If your ribbon has a right and wrong side, you may have to twist it twice so that you don't run across the wrong side of the ribbon.

4. 4

   Wrap the ribbon around the back of the box and back to the front end. Elevator the box upward again. Pull the longer part of the ribbon behind the box and out the other side. Set the box down once again.^[iv]

   • Place your thumb against the twisted part to keep it secure equally you lot wrap the ribbon around the back.

5. five

   Measure the ribbon against the first slice and cut it. Bring your ribbon back towards the middle of the box. Measure it against the end of the ribbon from the beginning and cut information technology.^[5]

6. half-dozen

   Wrap the ribbon under the twisted part. Pull the ribbon across the forepart of the twisted function at an bending. Bring it nether the twisted function, and back out the way y'all started. Pull on both ends of the ribbon to tighten the knot.^[6]

7. 7

   Necktie the ribbon into a bow. Fold both ends of the ribbon into loops. Cross the left loop over the right one to make a smaller loop in the middle. Pull the left loop through that smaller loop, and then pull to tighten.^[7]

8. 8

   Adjust the bow, then trim off the excess ribbon. Take a moment to adjust the loops and the tails.^[8] If you used a wired ribbon, y'all can fluff the loops up as well. For a fancier touch, cut the ends of the tails into angles or Vs.^[9]

Advertisement

1. 1

   Drape your ribbon beyond the meridian left corner of the box. Leave about 4 to 8 inches (10.16 to 20.32 centimeters) hanging off of the left side of the corner. Keep the residue of the ribbon on the spool on the meridian edge.^[ten]

2. 2

   Wrap the ribbon behind the summit correct corner. Accept the spool-side of the ribbon and pull it backside the top correct corner, downwardly towards the bottom right corner.^[11]

   • Keep your thumb over the ribbon on the top left corner so that information technology doesn't fall off.

3. 3

   Wrap the ribbon across the bottom right corner and under the bottom left corner. Keep the wraps nice and snug and so that they don't slide off of the corners.^[12]

4. 4

   Bring the ribbon back towards the top left corner. At this point, it would be a good idea to take a moment to suit the positions of the wrapped ribbons on each of the corners. If they look similar they are slipping off, pull them further from the corners.^[xiii]

5. five

   Cut off the excess ribbon. Bring both ribbons towards the middle of the acme left corner. Measure the spool ribbon confronting the other ribbon, and cut it down to match.^[fourteen]

6. 6

   Cross and tie the ribbons. Cross the left ribbon over and under the right, then tug on both ends to tighten them. Fold both ribbons into loops, then cross the right i over the left—just like tying a shoe!^[15]

7. seven

   Trim the backlog ribbon to clean up the bow. Once the bow is tight and secure, snip off the excess ribbon at the tails.^[16] For a fancier touch on, cut them at angles or into notches.

Advert

1. 1

   Cut four pieces of ribbon for the length of the box. You will need four pieces of ribbon that are long enough to wrap around the box lengthwise, plus an additional two inches (5.08 centimeters).^[17]

   • For a unique look, consider using 2 pieces of sparse ribbon, and two pieces of slightly wider ribbon. Yous can also utilise two contrasting colors instead.
   • Thick and/or wired ribbon is not a skillful choice. Use thin satin or airship ribbon for best results.

2. 2

   Cut four pieces of ribbon for the width of the box. Use the same ribbon as in the previous step. This time, cutting the ribbon long plenty then that information technology tin wrap effectually the box widthwise, plus 2 inches (5.08 centimeters).^[18]

3. three

   Set the first set of ribbons side-past-side downwards on the table. Have the iv long ribbons, and set them downwardly on the table. Make sure that they are parallel to each other and spaced no more than than ¼ inch (0.64 centimeters) autonomously.^[nineteen]

   • If you used different widths and/or colors, exist sure to alternate them.

4. 4

   Place your souvenir face-downward on the ribbons. The box tin can exist centered or off-middle, depending on where yous want the ribbons to be.

5. 5

   Wrap the ribbons around the box and secure them with double-sided tape. Wrap and tape each of the ribbons one at a time; do non record all of them at once. Pull the ribbons firmly around the box so that they are nice and snug. The ribbon ends volition overlap each other past about 1 inch (2.54 centimeters).^[20]

   • Brand certain that you are only taping the acme ribbon to the bottom ribbon; don't tape the ribbons to the box itself.
   • You can besides use gum dots (found in the scrapbooking aisle of an arts and crafts store) instead of double-sided tape.

6. vi

   Secure the next set of ribbons right in a higher place the showtime set. Place a strip of double-sided tape onto the end of each of your brusk ribbon. Arrange the ribbons right above the first, long ribbon, making certain that the ends are perpendicular to it.^[21]

   • Once again, go along the ribbons spaced no more than ¼ inch (0.64 centimeters) autonomously.

7. 7

   Flip the box over and weave the brusk ribbons through the first gear up of ribbons. Pull your short ribbons around to the front end of the box. Weave the get-go one over and under across the first set of ribbons. Weave the adjacent ribbon nether and over, so on. Proceed weaving until you have woven all four ribbons.^[22]

8. viii

   Secure the ribbons to the dorsum of the box. Flip the box again. Secure a strip of double-sided tape to the cease of each ribbon, then press the ribbons downwardly i by one to the dorsum of the box. Make sure that the ends of the ribbons match upward.^[23]

   • For a nicer impact, weave the brusk ribbons through the long ribbons on the back, merely like yous did for the front.

9. 9

   Add a decoration to the front, if desired. The woven ribbons are part of the design. If you feel that your gift is lacking something, you can buy or brand a matching bow, then secure it to the box. Instead of roofing upwardly all your difficult work, set the bow off to the side so that the weaving is still visible.

   • Don't be agape to become artistic! Try adding a squeamish tag, a pom pom or tassel, or even a pretty piece of leafage under the ribbon.^[24]

Ad

Add together New Question

• Question

  How exercise I tie a actually stiff ribbon?

  

  Try to "massage" and soften up your ribbon before you are going to tie it so that is less potent.

• Question

  How do I necktie a ribbon on the corners?

  

  You can just record the ribbons to the corner of the box.

• Question

  When I twist the ribbons, they brand information technology and so the small jewelry box tin can't sit apartment. What tin can I exercise to terminate that?

  

  Use two or even iii lengths of ribbon. Wrap one length horizontally around the box and tape it in identify on the bottom of the box, using tape that won't harm the box; it only needs to exist long enough to go around the box. Wrap a longer ribbon vertically around the box and necktie it and so the bow is on the lid of the box, or use a length of ribbon just long plenty to round the box and record it on the lesser once more. Tie a bow with a tertiary length of ribbon around where the two ribbons meet on the box lid.

Enquire a Question

200 characters left

Include your email accost to get a bulletin when this question is answered.

Submit

Ad

Video

• Satin and grosgrain ribbons piece of work peculiarly well for gifts, only if you want to be able to shape the loops of the bow, you demand to get a wired ribbon.

• If your gift wrap is a single, solid color, choose a contrasting color for a assuming wait (ie: red ribbon on a greenish box).

• Cull a ribbon color that goes great with the gift wrap. For example, a gold ribbon for a red box and a silver ribbon for a blue ane.

Advertisement

Things You'll Need

• Gift box
• Ribbon
• Scissors
• Double-sided tape (for woven ribbon)

About This Commodity

Article Summary X

To tie a ribbon around a box, start by draping the ribbon horizontally beyond the top of the box with 4-8 inches left hanging to the side for the bow. Then, pull the long stop of the ribbon nether the box and back upwardly to the top, crossing it with the brusque end so both ends are lying vertically on the box. Side by side, pull the ribbon under the box and back up to the top then you've made plus signs on the bottom and the tiptop. You lot can then wrap both ends of the ribbon under the centre and pull them up into a knot. Cut the long end to the length of the brusk stop so your bow will be even, then fold both ends into loops, cross them, and tie them into a bow. To learn how to present a pretty gift by tying your ribbon on the diagonal, keep reading!

Did this summary assist you?

Thanks to all authors for creating a folio that has been read 534,795 times.

Did this article aid you?

sandovalyestioured.blogspot.com

Source: https://www.wikihow.com/Tie-a-Ribbon-Around-a-Box

Share this post